Well foot valve repair diagnostic questions answers.
Deep well jet pump foot valve troubleshooting.
It could be a broken water line from the well to the house usually you ll have a wet area between the well head and the house a bad check valve just above the submersible pump at the bottom of the well a bad connector leaving the well casing or even a broken water line inside the well casing.
These questions and answers address common problems with well piping foot valves or check valves including their relation to loss of well pump prime.
Defective or plugged check valve or foot valve and or strainer.
Pull valve and inspect.
You are using the wrong pre charge air pressure in the bladder style pressure tank.
If well is weak lower ejector deep well use a tail pipe deep well or switch from shallow well to deep well equipment.
The jet pump cycles too frequently if your jet pump cycles too often there are a few possible causes.
Remove ejector and inspect.
Each of these problems requires a pro.
This article series describes the foot valve used on well piping for water well pumps water wells.
The check valve or foot valve is leaking.
Most well pumps are used in conjunction with a pressure tank.
Well pumps are designed to.
Partial clogging will reduce delivery.
How to troubleshoot residential well problems.
When your well stops pumping water it doesn t necessarily mean you have to purchase a new well pump or dig a new well.
The standard pressure tank is water logged.
Clean and reinstall if dirty.
The pressure switch needs to be adjusted.
The goal of the well water pump system is to maintain a constant supply of pressurized water in the house and piping system.
Some wells have pumps called jet pumps that are located on the surface or top of the well.
A foot valve is located at the bottom of a well and acts like a one way check valve allowing water to go up the pipe toward the house but not drain backward into the well.
We explain what a foot valve is how they work why they are used and how to diagnose.